FairCom ISAM for C

GetLTEKey

Search index file for entry equal to or less than target.

Short Name

LTEKEY()

Type

Low-Level index file function

Declaration

LONG GetLTEKey(FILNO keyno, pVOID target, pVOID idxval)

Description

In V12 the file number typedef was formally changed from COUNT, a two-byte value to FILNO, a four-byte value. Refer to this link for compatibility details. Four Byte File Numbering

GetLTEKey() searches index file keyno for the last entry which is equal to, or less than, the key value pointed to by target. If such an entry exists, it is copied into the area pointed to by idxval.

Return

If GetLTEKey() is successful, it returns the data record position associated with the entry found in the index. If an error occurs or no such entry exists, (either the index is empty or the target key value exceeds all entries in the index), GetLTEKey() returns a zero. When GetLTEKey() returns a zero, check the value of uerr_cod: if uerr_cod is non-zero, an error condition was detected; otherwise, no key value satisfied the search. See FairCom DB Error Codes for a complete listing of valid FairCom DB error values.

Example

FILNO keyno;

TEXT target[24], idxval[24];

pTEXT suffix;

/* Key length = 23. Assuming duplicates are allowed, the *

* last four bytes are for the suffix. */

memset(target, NULL, 24);

scanf("%19s",target);

suffix = target + 20; /* pointer to the last four bytes */

for (i = 0;i++ < 4;) /* set suffix to highest possible */

*suffix++ = C255; /* value */

if (GetLTEKey(keyno,target,idxval))

printf("\nthe key value >= %.19s is %.19s", target, idxval);

Limitations

No check is made to determine if idxval points to a region sufficiently large to accept a key value from the index file. If the area is too small, either code or data will be clobbered.

Note: The key value returned by this function will be a properly formatted key value (i.e., HIGH_LOW order, forced to upper case, etc.). The main issue this presents is if binary key values will be displayed on a LOW_HIGH machine, it will be necessary to reverse any numeric segments.

The recbyt parameter in this function is a 4-byte value capable of addressing at most 4 gigabytes. If your application supports HUGE files (greater than 4 gigabytes), you must use the ctSETHGH() and ctGETHGH() functions to set or get the high-order 4 bytes of the file offset. See also Record Offsets Under Huge File Support.